Bubble nails technique11/24/2023 ![]() And if your bead is too dry, the bead will likely have a dry powder coating and will not have a smooth surface. If your bead is too wet, depending on the angle of the brush, the bead will flatten out on the brush hairs and drip off. This will allow for a quick, easy release onto the nail. When trying to achieve a perfect mix ratio, the first thing to remember is you want a minimal amount of the bead attached to the brush hairs. An easy way to spot an improper mix ratio is to look at how the bead appears on the brush. Each product line mixes a little differently, and it takes some time to master the proper mix ratio. If the nails are pinched too tightly you can cause damage and even cause a break in the enhancement.įor gels, you can use clips to help hold the C-curve shape, and for acrylics you can use C-curve sticks to help bend the enhancement around to give you that perfect C-curve shape.Īnother very common problem with acrylics is not getting the proper mix ratio of liquid to powder. When pinching the nail, remember to use only a bit of pressure to gently mold the curve into the “C” shape. So whether you’re using acrylic or gel, make sure the form fits correctly underneath the nail and that it follows the nail’s natural curvature. ![]() Pinching is usually done with the fingers or specially designed tweezers, where pressure is applied to the sidewalls of the nail to help “bend” the free edge of the extension into a nice “C” shape.Ĭ-curves begin during the sculpting stage. ![]() The C-curve really shows how well an enhancement has been applied, and C-curves that are too flat will look unnatural and gawky. This makes the nail bed a little bigger and ensures complete gel-polish coverage. The thumb and forefinger of the holding hand pinch the client’s finger to pull back the soft tissue from the nail plate. And you can use balance point positioning to keep a steady hand and get better nail coverage. ![]() Use three long, fluid strokes: one down the center, then two on either side. Most manufacturers will recommend two coats for solid color coverage, so use the three stroke method to help keep your applications thin. When the gel-polish has been applied too thickly, the suggested manufacturer curing time might not be enough to create a full cure, which can lead to peeling. With gel-polish it’s important to be able to get a good cure so the color will create a hard surface that will stay on without chipping for at least two weeks. One coat is typically enough, and applying too much primer can actually decrease adhesion. Remember when applying primer to keep it off the skin, as it can be an irritant, and to keep applications thin. Nail techs unfortunate enough to have gone through this will likely never forget again, as clients will soon be coming in upset that their acrylics are coming off. Most acrylic does not stick well to the natural nail, so a primer is used with a chemical makeup of monomers that bond to the nail as well as to the acrylic so the bond is extra strong. Primer is specifically designed for getting acrylic to adhere better to the nail. Forgetting to put primer on before acrylicĪ problem for many techs when they first start - forgetting to put primer onto the nails before the acrylic application - will directly lead to nail enhancements lifting and popping off the nails.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |